• Products & Services

    Lubricants

     

    K sticks CLIPVal-Tex 972 is formulated for high pressure and high temperature oilfield services. It contains moly-disulphide to reduce operating torque and galling while maintaining superior sealability. Typical applications are in high pressure plug valves and manifold ball valves commonly used on well servicing jobs, rigs, FPSO’s, etc. Allows for easy injection and smooth valve torque down to -20 F. Always use stick.

    Lube Sealant J Carton_300dpiVal-Tex’s most viscous product is developed for maximum sealability for valves in high pressure and high temperature oilfield services. It contains moly-disulphide to reduce operating torque and galling. Typical applications are in high pressure plug valves and manifold ball valves commonly used on well servicing jobs, rigs, FPSO’s, etc. Allows for easy injection and smooth valve torque down to -20 F. Always use stick.

    VF Assorted_300dpi(1)Superior performance where sour gas and CO2 are present. Val-Tex 700 is good for use to -20 F. Val-Tex 750 is used in extreme low temperature services to -50 F. Always use stick.

    Valve Flush carton(1)

    Superior product that will reduce lubrication frequency while improving valve performance.

    Val-Tex PL-1000 is a non-petroleum product and is highly resistant to washout and pressure.
    It contains no solid fillers which can harden in your valve and lubrication equipment.

    Val-Tex PL-1000 is good for low temperature use to -20 F.

    QS-2000A ball valve field

    1502 is formulated using SURE SEAL technology for the toughest high pressure plug valve applications.  Val-Tex SURE SEAL 1502 is for use during assembly only to help ensure maximum sealing and resistance to washout, especially during low pressure testing.

    The assembly process for using Val-Tex 1502 follows:

    STEP 1:   Roll the plug in the Val-Tex SURE SEAL 1502 to completely coat the surface.
    STEP 2:   Liberally apply Val-Tex SURE SEAL 1502 to the o-ring in the face of each segment and seals in the body of the valve.
    STEP 3:   After assembling per the manufacturer’s  procedure, inject Val-Tex stick lube sealant. Inject to a minimum of 4,000 PSI for a bottom entry valve or a minimum of 6,000 PSI for a top entry valve.

     

    TO ENSURE MAXIMUM SEALING AND PERFORMANCE:

    YOU MUST TOP THE VALVE OFF WITH VAL-TEX STICK GREASE. VAL-TEX STICK GREASE HAS BEEN TESTED WITH VAL-TEX 1502 TO ENSURE COMPATIBILITY AND PERFORMANCE. FAILURE TO INJECT VAL-TEX STICK GREASE CAN COMPROMISE THE ABILITY OF THE VALVE TO HOLD PRESSURE AND INCREASE OPERATING TORQUE.